Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
- 8. Transmissions
   + 8.1. Mechanical transmission
   - 8.2. Automatic transmission
      8.2.1. Technical characteristics
      8.2.2. Gear shifting rope
      8.2.3. Gear shifting lever
      8.2.4. Epiploon of half shafts
      8.2.5. Transmission cooling system
      8.2.6. Switch of inclusion of a low gear
      8.2.7. The switch of lamps of the back course / the blocking switch
      8.2.8. Switches of an operating mode of the transmission
      8.2.9. Temperature sensor
      8.2.10. Speed sensors
      8.2.11. Electronic control unit
      8.2.12. Transmission
      8.2.13. Partition of the automatic transmission
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




8.2.7. The switch of lamps of the back course / the blocking switch

GENERAL INFORMATION

The switch of lamps of the back course / the blocking switch

1 – big nut;

2 – switching lever shaft;

3 – driving lever

Shooters specified fastenings of the switch.


Adjustment of the switch of lamps of the back course / the blocking switch


1 – switching lever shaft;

2 – flute;

3 – fixing nut of the switch

Shooters specify that the shaft of the lever of switching is combined with a flute on the switch case.

Removal

PERFORMANCE ORDER
1. Include neutral transfer.
2. Disconnect a wire of the minus plug of the accumulator.
3. Pick up the probe phone for check of level of liquid of the automatic transmission.
4. Disconnect a switching rope from the lever on the transmission.
5. Disconnect the socket of connection of the switch.
6. Turn off the nut fixing the driving lever to a switching lever shaft then remove a clamping plate and turn off the big nut fixing the switch to a shaft (see rice. The switch of lamps of the back course / the blocking switch).
7. Turn off the nut fixing the switch to the transmission and remove the switch.

Installation

PERFORMANCE ORDER
Installation is carried out upside-down removals. Replace a sealing ring of a tube of the probe for check of level of liquid of the automatic transmission.

Adjustment

PERFORMANCE ORDER
1. Disconnect a switching rope from the lever to the transmission.
2. Translate the lever on the transmission up to the end to the right, then turn it back on two divisions to the provision of a neutral broadcast "N" (see rice. Adjustment of the switch of lamps of the back course / the blocking switch).
3. The flat surface of a shaft of the lever of switching has to be combined with a flute in the switch case. If it is necessary, turn off a fixing nut and turn the switch.
4. Upon completion of adjustment tighten a fixing nut of the switch till the required inhaling moment.

On the homepage