Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Ventilation and heating
- 5. Power supply system
   + 5.1. Carburetor engines
   - 5.2. Models with fuel injection
      5.2.1. Technical characteristics
      5.2.2. Precautionary measures
      5.2.3. Elements of system of injection of fuel
      5.2.4. Unleaded gasoline
      5.2.5. Electronic control unit
      5.2.6. Casing of the air filter
      5.2.7. Air filter
      5.2.8. Resonator, air filter
      5.2.9. Fuel injection block (Multec of TsVT)
      5.2.10. Case of a butterfly valve (Multec of MW)
      5.2.11. Case of a butterfly valve (Multec-S)
      5.2.12. Case of a butterfly valve (Motronic M 1.5)
      5.2.13. Case of a butterfly valve (Motronic M 2.5 and M 2.8)
      5.2.14. Case of a butterfly valve (Simtec)
      5.2.15. Fuel injector of Multec of TsVT
      5.2.16. Fuel injectors of Multec of MW
      5.2.17. Fuel injectors (Motronic M 1.5)
      5.2.18. Fuel injectors (Motronic M 2.5 and M 2.8)
      5.2.19. Fuel injectors (Simtec)
      5.2.20. Fuel pressure regulator
      5.2.21. Sensor of provision of a butterfly valve
      5.2.22. Potentiometer of a butterfly valve
      5.2.23. Solenoid of system of idling
      5.2.24. Electromagnetic valve of system of idling
      5.2.25. The solenoid regulating air supply in system of idling
      5.2.26. Pressure sensor in an inlet collector
      5.2.27. Sensor of speed of rotation and provision of a bent shaft
      5.2.28. Sensor of temperature of cooling liquid
      5.2.29. Oxygen sensor
      5.2.30. The sensor of temperature of the arriving air
      5.2.31. Air stream sensor
      5.2.32. Sensor of detonation combustion of fuel
      5.2.33. Sensor of position of the camshaft
      5.2.34. Blowing-off valve of the coal filter
      5.2.35. Fuel pump
      5.2.36. Fuel filter
      5.2.37. Accelerator rope
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




5.2.37. Accelerator rope

Removal and installation

PERFORMANCE ORDER
1. Removal and installation of a rope is carried out to similarly carburetor models (see subsection 5.1.10)
2. On some models the rope is connected to the lever of a butterfly valve via the spherical hinge. For fastening of a rope the plug installed in an arm on an inlet collector is also used. Remove a fixing clip of the spherical hinge (a photo at the left) and remove the plug from an arm (a photo on the right).

Adjustment

Adjustment of a rope is carried out to similarly carburetor models (see subsection 5.1.10)

On the homepage