Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   + 3.3. Diesel engines
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. System of electric equipment
      + 3.4.3. System of ignition
      3.4.4. Accumulator
      3.4.5. System of recharge of the accumulator
      3.4.6. Maple belt
      3.4.7. Multiband driving belt
      - 3.4.8. Generator
         3.4.8.1. Brushes of the generator and voltage stabilizer (Delco-Remy generator)
         3.4.8.2. Brushes of the generator and voltage stabilizer (Bosch generator)
      3.4.9. System of start of the engine
      + 3.4.10. Starter
      3.4.11. Distributor of ignition (model 14 NV)
      3.4.12. Ignition distributor (14 SE, C 14 NZ and C 16 NZ)
      3.4.13. Ignition distributor (C 18 NZ and C 20 NZ)
      3.4.14. Ignition distributor (early models C 20 XE)
      3.4.15. Ignition coil
      3.4.16. Module of distribution of ignition
      3.4.17. The amplifier on the ignition coil
      3.4.18. Switch of an alarm bulb of low pressure of oil
      3.4.19. Oil level sensor
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.4.8.1. Brushes of the generator and voltage stabilizer (Delco-Remy generator)

GENERAL INFORMATION

Delco-Remy generator

A – fixing screws of the holder of brushes;

In – fixing screws of the holder of brushes / voltage stabilizer

 Removal of the drill holding brushes in the holder
 

Removal

PERFORMANCE ORDER
1. Remove the generator.
2. Mark the provision of installation of halves of the case of the generator. Turn off three fixing bolts and divide case halves.
3. Check a condition of tokosjemny rings and clear them if it is necessary
(tokosjemny rings of the generator are specified by shooters) – the Delso-Remy generator.
4. Turn off three fixing nuts and remove the stator.
5. Turn off the contact screw and remove the diode block.
6. Turn off two screws and remove the holder of brushes. Check a condition of brushes and replace them if it is necessary.

Installation


Installation is carried out upside-down removal removals.
On the homepage