Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   + 3.3. Diesel engines
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. System of electric equipment
      + 3.4.3. System of ignition
      3.4.4. Accumulator
      3.4.5. System of recharge of the accumulator
      3.4.6. Maple belt
      3.4.7. Multiband driving belt
      + 3.4.8. Generator
      3.4.9. System of start of the engine
      + 3.4.10. Starter
      3.4.11. Distributor of ignition (model 14 NV)
      3.4.12. Ignition distributor (14 SE, C 14 NZ and C 16 NZ)
      3.4.13. Ignition distributor (C 18 NZ and C 20 NZ)
      3.4.14. Ignition distributor (early models C 20 XE)
      3.4.15. Ignition coil
      3.4.16. Module of distribution of ignition
      3.4.17. The amplifier on the ignition coil
      3.4.18. Switch of an alarm bulb of low pressure of oil
      3.4.19. Oil level sensor
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.4.6. Maple belt

GENERAL INFORMATION

Nuts and bolts of the lower fastening of the generator


Shooters specified nuts and bolts of the lower fastening of the generator.

The top fastening of the generator is disconnected – the Bosch generator.

Removal

PERFORMANCE ORDER
1. Remove the air filter.
2. Take off a driving belt of the pump of system of hydrostrengthening of steering if it is necessary.
3. Weaken fixing nuts of the generator, reject it to the engine and take off a belt from pulleys.

Installation

Installation is carried out upside-down removals.

Tension

PERFORMANCE ORDER
1. The driving belt has to be tense so that when pressing by a thumb with average effort in the middle of the longest site of a belt, it caved in approximately on 13,0 mm.
2. Adjust a belt tension, changing position of the generator.

On the homepage