Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   + 3.3. Diesel engines
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. System of electric equipment
      + 3.4.3. System of ignition
      3.4.4. Accumulator
      3.4.5. System of recharge of the accumulator
      3.4.6. Maple belt
      3.4.7. Multiband driving belt
      + 3.4.8. Generator
      3.4.9. System of start of the engine
      + 3.4.10. Starter
      3.4.11. Distributor of ignition (model 14 NV)
      3.4.12. Ignition distributor (14 SE, C 14 NZ and C 16 NZ)
      3.4.13. Ignition distributor (C 18 NZ and C 20 NZ)
      3.4.14. Ignition distributor (early models C 20 XE)
      3.4.15. Ignition coil
      3.4.16. Module of distribution of ignition
      3.4.17. The amplifier on the ignition coil
      3.4.18. Switch of an alarm bulb of low pressure of oil
      3.4.19. Oil level sensor
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.4.4. Accumulator

Check

The accumulator does not demand a dolivka of electrolyte and check of its density. For check of a condition of the accumulator the indicator serves.

Charging

PERFORMANCE ORDER
1. For accumulator charging remove it from the car.
2. Charging of this type of accumulators demands much more time, than charging of ordinary accumulators. Exercises need to be done at a voltage of 13,9-4,9 Volts, current of charging should not exceed 25 Amperes.
3. For charging of completely discharged accumulator (lower than 12,2 Volts) address experts.

Removal

PERFORMANCE ORDER
1. The accumulator is located in the left forward corner of a motive compartment.
2. Disconnect a wire at first of the minus, and then plus plug of the accumulator. Turn off a bolt of a clip and remove the accumulator.

Installation

Installation is carried out upside-down removals.

On the homepage