Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   + 3.3. Diesel engines
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. System of electric equipment
      + 3.4.3. System of ignition
      3.4.4. Accumulator
      3.4.5. System of recharge of the accumulator
      3.4.6. Maple belt
      3.4.7. Multiband driving belt
      + 3.4.8. Generator
      3.4.9. System of start of the engine
      + 3.4.10. Starter
      3.4.11. Distributor of ignition (model 14 NV)
      3.4.12. Ignition distributor (14 SE, C 14 NZ and C 16 NZ)
      3.4.13. Ignition distributor (C 18 NZ and C 20 NZ)
      3.4.14. Ignition distributor (early models C 20 XE)
      3.4.15. Ignition coil
      3.4.16. Module of distribution of ignition
      3.4.17. The amplifier on the ignition coil
      3.4.18. Switch of an alarm bulb of low pressure of oil
      3.4.19. Oil level sensor
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.4.12. Ignition distributor (14 SE, C 14 NZ and C 16 NZ)

Removal

PERFORMANCE ORDER
1. Disconnect wires of high voltage from spark plugs and the coil of ignition.
2. Uncover the ignition distributor together with wires of high voltage.
3. Disconnect the socket of connection of the distributor of ignition.
4. Further removal of the distributor of ignition is carried out similar to models 14 NV:
  – adjusting mechanisms (are led round by a circle) on the distributor of ignition and a casing of the valvate mechanism – the models C 14 NZ;
  – the runner is combined with an arrow (it is led round by a circle) on the ignition distributor case – the model C 14 NZ;
  – remove the plastic screen;
  – check that the runner was combined with a mark (it is led round by a circle) on the ignition distributor – the model C 14 NZ;
  – removal of a clamping plate;
  – removal of the distributor of ignition – model
FROM 14 NZ

Partition

PERFORMANCE ORDER
For replacement of the plastic plug beat out a cylindrical pin. Other elements are not subject to replacement and if the distributor of ignition is faulty, it needs to be replaced.

Installation

PERFORMANCE ORDER
1. Replace a sealing ring if it is necessary.
2. Installation of the distributor of ignition is carried out similar to models 14 NV.

On the homepage