Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   - 3.3. Diesel engines
      3.3.1. Gear belt
      3.3.2. The 1,7 l diesel engine with a turbo-supercharging
      3.3.3. Tension of a gear belt
      3.3.4. The diesel TC4EE1 engine of 1,7 l with a turbo-supercharging
      3.3.5. Head of the block of cylinders
      3.3.6. The diesel TC4EE1 engine with a turbo-supercharging
      3.3.7. Check of a head of the block of cylinders and the block of cylinders on straightforwardness
      3.3.8. Camshaft
      3.3.9. Gas distribution phases
      3.3.10. Camshaft case cover oil separator
      3.3.11. Check and adjustment of gaps in the drive of valves
      3.3.12. Removal and installation of valves
      3.3.13. Replacement of oil scraper caps
      3.3.14. Grinding of valves
      3.3.15. Grinding in of valves
      3.3.16. Check of a gap in the directing plugs of valves
      3.3.17. Check of the directing plugs of valves
      3.3.18. Check of a compression
      3.3.19. Wedge-shaped belt
      3.3.20. Oil case
      3.3.21. Oil pump
      3.3.22. Safety valve
      3.3.23. Thermostat
      3.3.24. Check of kalilny candles
      3.3.25. Check of system of preliminary heating
      3.3.26. Removal of air from fuel system
      3.3.27. Check and adjustment of turns of idling
      3.3.28. Removal and installation of nozzles
      3.3.29. Check of an advancing of injection of fuel
      3.3.30. Heating of the fuel filter
      3.3.31. Replacement of the filtering element of the air filter
      3.3.32. Discharge of water from the fuel filter
      + 3.3.33. Useful tips
   + 3.4. Engine electric equipment
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.3.4. The diesel TC4EE1 engine of 1,7 l with a turbo-supercharging

GENERAL INFORMATION

The vacuum pump is fixed on the back party of the generator and is put in action from the last.

Removal

PERFORMANCE ORDER
1. Disconnect a vacuum hose.
2. Disconnect a tube for an oil supply.
3. Turn off bolts of fastening of the vacuum pump and to remove the pump together with a sealing ring.

Installation

PERFORMANCE ORDER
1. Check a sealing ring for absence of damage, if necessary to replace.
2. Install the vacuum pump with a sealing ring into place and to tighten fastening bolts the moment of 7 Nanometers.
3. Fill in about 5 cm3 of engine oil in an entrance opening of the vacuum pump.
4. Establish a tube for an oil supply with new sealing rings and to fix by its moment 25 Nanometers.
5. Establish and fix a vacuum hose.
On the homepage