Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   - 3.3. Diesel engines
      3.3.1. Gear belt
      3.3.2. The 1,7 l diesel engine with a turbo-supercharging
      3.3.3. Tension of a gear belt
      3.3.4. The diesel TC4EE1 engine of 1,7 l with a turbo-supercharging
      3.3.5. Head of the block of cylinders
      3.3.6. The diesel TC4EE1 engine with a turbo-supercharging
      3.3.7. Check of a head of the block of cylinders and the block of cylinders on straightforwardness
      3.3.8. Camshaft
      3.3.9. Gas distribution phases
      3.3.10. Camshaft case cover oil separator
      3.3.11. Check and adjustment of gaps in the drive of valves
      3.3.12. Removal and installation of valves
      3.3.13. Replacement of oil scraper caps
      3.3.14. Grinding of valves
      3.3.15. Grinding in of valves
      3.3.16. Check of a gap in the directing plugs of valves
      3.3.17. Check of the directing plugs of valves
      3.3.18. Check of a compression
      3.3.19. Wedge-shaped belt
      3.3.20. Oil case
      3.3.21. Oil pump
      3.3.22. Safety valve
      3.3.23. Thermostat
      3.3.24. Check of kalilny candles
      3.3.25. Check of system of preliminary heating
      3.3.26. Removal of air from fuel system
      3.3.27. Check and adjustment of turns of idling
      3.3.28. Removal and installation of nozzles
      3.3.29. Check of an advancing of injection of fuel
      3.3.30. Heating of the fuel filter
      3.3.31. Replacement of the filtering element of the air filter
      3.3.32. Discharge of water from the fuel filter
      + 3.3.33. Useful tips
   + 3.4. Engine electric equipment
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.3.27. Check and adjustment of turns of idling

GENERAL INFORMATION

For regulation of turns of idling use the tachometer which is specially intended for diesel engines working at photo cells. For example, the tachometer of Zikomat of Gossen has the photo diode and reacts to light reflected by a white marking strip in a crankshaft pulley.

PERFORMANCE ORDER
1. To put with chalk on a pulley of a bent shaft a tag 1-2 cm wide or to paste a piece of aluminum foil of the same size.
2. Start the engine and to warm up up to the working temperature.
3. To switch off everything electric consumers.
4. Check speed on a tachometer.
5. Turn off a lock-nut on TNVD (on a photo at the left – the diesel 17YD, on the right – the diesel TC4EE1 with a turbo-supercharging)
6. Determine speed by means of the screw of adjustment of turns of idling within 820 - 880 rpm.
7. To Zakontrit the adjusting screw a varnish.

On the homepage