Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   + 3.2. DOHC engines
   - 3.3. Diesel engines
      3.3.1. Gear belt
      3.3.2. The 1,7 l diesel engine with a turbo-supercharging
      3.3.3. Tension of a gear belt
      3.3.4. The diesel TC4EE1 engine of 1,7 l with a turbo-supercharging
      3.3.5. Head of the block of cylinders
      3.3.6. The diesel TC4EE1 engine with a turbo-supercharging
      3.3.7. Check of a head of the block of cylinders and the block of cylinders on straightforwardness
      3.3.8. Camshaft
      3.3.9. Gas distribution phases
      3.3.10. Camshaft case cover oil separator
      3.3.11. Check and adjustment of gaps in the drive of valves
      3.3.12. Removal and installation of valves
      3.3.13. Replacement of oil scraper caps
      3.3.14. Grinding of valves
      3.3.15. Grinding in of valves
      3.3.16. Check of a gap in the directing plugs of valves
      3.3.17. Check of the directing plugs of valves
      3.3.18. Check of a compression
      3.3.19. Wedge-shaped belt
      3.3.20. Oil case
      3.3.21. Oil pump
      3.3.22. Safety valve
      3.3.23. Thermostat
      3.3.24. Check of kalilny candles
      3.3.25. Check of system of preliminary heating
      3.3.26. Removal of air from fuel system
      3.3.27. Check and adjustment of turns of idling
      3.3.28. Removal and installation of nozzles
      3.3.29. Check of an advancing of injection of fuel
      3.3.30. Heating of the fuel filter
      3.3.31. Replacement of the filtering element of the air filter
      3.3.32. Discharge of water from the fuel filter
      + 3.3.33. Useful tips
   + 3.4. Engine electric equipment
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.3.22. Safety valve

GENERAL INFORMATION

The safety valve supports oil pressure at the certain level. It is behind a pulley of a bent shaft on the oil pump. If the control lamp of emergency pressure of oil lights up or blinks in spite of the fact that the level of oil is normal, it indicates the low pressure of oil. In that case it is necessary to remove the safety valve, to disassemble it and to check.

Removal

PERFORMANCE ORDER
1. Turn out a stopper and to take out a spring and a plunger.
2. Check a plunger for ease of movement. If necessary to clear or replace it.

Installation

PERFORMANCE ORDER
To insert the plunger and a spring which are washed out in kerosene. Establish new copper laying under a stopper and to tighten it.

On the homepage