Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   - 3.2. DOHC engines
      3.2.1. Technical characteristics
      3.2.2. Covers of a gas-distributing belt (X 16 XEL)
      3.2.3. Covers of a gas-distributing belt (all models, except X 16 XEL)
      3.2.4. Gas-distributing belt (X 16 XEL)
      3.2.5. A gas-distributing belt (all models, except X 16 XEL)
      3.2.6. Cover of a head of cylinders
      3.2.7. Asterisks of camshafts (X 16 XEL)
      3.2.8. Asterisks of camshafts (all models, except X 16 XEL)
      3.2.9. Camshaft epiploons
      3.2.10. Natyazhitel of a gas-distributing belt and intermediate pulley
      3.2.11. Camshafts
      3.2.12. Head of cylinders (X 16 XEL)
      3.2.13. A head of cylinders (all models, except X 16 XEL)
      3.2.14. Head of cylinders
      3.2.15. Hydraulic elevators of valves
      3.2.16. Oil pallet (X 16 XEL)
      3.2.17. Asterisk of a bent shaft
      3.2.18. Oil pump
      3.2.19. Epiploons of a bent shaft
      3.2.20. Engine and transmission
      3.2.21. Oil cooler
   + 3.3. Diesel engines
   + 3.4. Engine electric equipment
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.2.7. Asterisks of camshafts (X 16 XEL)

Removal

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator.
2. Turn a bent shaft on 16 ° from VMT.
3. Take off a gas-distributing belt.
4. Remove the top part of an inlet collector.
5. Disconnect wires of spark plugs.
6. Disconnect ventilating hoses from a cover of a head of cylinders and uncover.
7. Remove asterisks of camshafts.

Installation

PERFORMANCE ORDER
1. Establish asterisks by synchronizing tags outside.
2. Make sure that asterisks are put on adjusting pins.
3. On an asterisk of a shaft of final valves there is a thickening (1 – an asterisk of a shaft of final valves, 2 – an asterisk of a shaft of inlet valves, 3 – a thickening).
4. Insert new bolts and tighten them. Establish the remained details.

On the homepage