Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. SOHC engines
   - 3.2. DOHC engines
      3.2.1. Technical characteristics
      3.2.2. Covers of a gas-distributing belt (X 16 XEL)
      3.2.3. Covers of a gas-distributing belt (all models, except X 16 XEL)
      3.2.4. Gas-distributing belt (X 16 XEL)
      3.2.5. A gas-distributing belt (all models, except X 16 XEL)
      3.2.6. Cover of a head of cylinders
      3.2.7. Asterisks of camshafts (X 16 XEL)
      3.2.8. Asterisks of camshafts (all models, except X 16 XEL)
      3.2.9. Camshaft epiploons
      3.2.10. Natyazhitel of a gas-distributing belt and intermediate pulley
      3.2.11. Camshafts
      3.2.12. Head of cylinders (X 16 XEL)
      3.2.13. A head of cylinders (all models, except X 16 XEL)
      3.2.14. Head of cylinders
      3.2.15. Hydraulic elevators of valves
      3.2.16. Oil pallet (X 16 XEL)
      3.2.17. Asterisk of a bent shaft
      3.2.18. Oil pump
      3.2.19. Epiploons of a bent shaft
      3.2.20. Engine and transmission
      3.2.21. Oil cooler
   + 3.3. Diesel engines
   + 3.4. Engine electric equipment
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




3.2.18. Oil pump

Removal

PERFORMANCE ORDER
1. Remove a back cover of a gas-distributing belt.
2. Remove the oil pallet, a maslozaborny branch pipe and a dividing partition of the pallet.
3. In the models C 18 NZ and C 20 NE unscrew an oil filter.
4. Disconnect cooler tubes from the oil pump and remove them aside.
5. Disconnect wires from the switch of pressure of the oil fixed on the pump.
6. Remove a lock ring from the end of a bent shaft.
7. Unscrew fixing bolts and remove the pump. Remove old laying.

Installation

PERFORMANCE ORDER
1. Carefully clean the joined surfaces of the pump and the block of cylinders and establish new laying.
2. Wrap up the end of a bent shaft a thin tape not to damage an epiploon in installation time of the pump.
3. Establish a new epiploon, oil it and install the pump into place.
4. Tighten fixing bolts.
5. Establish a lock ring (A), previously having greased it with the pressurizing structure (strelkm are specified fixing bolts of the small pump).
6. Establish the remained details.
On the homepage