Opel Astra A

1991-1998 of release

Repair and operation of the car



Opel Astra A
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Technical characteristics
   - 2.2. Maintenance operations
      2.2.1. Introduction
      2.2.2. Current maintenance
      - 2.2.3. Maintenance through 15 000 km or each 12 months
         2.2.3.1. Engine oil and oil filter
         2.2.3.2. Check of hoses and connections on existence of leaks
         2.2.3.3. Check of steering and suspension bracket
         2.2.3.4. Check of boots of half shafts
         2.2.3.5. Check of level of liquid of the automatic transmission
         2.2.3.6. Survey and cleaning of a radiator
         2.2.3.7. Speed of idling and composition of fuel mix
         2.2.3.8. Check of system of production of the fulfilled gases
         2.2.3.9. Conducting check
         2.2.3.10. Ignition advancing corner
         2.2.3.11. Replacement of brake fluid
         2.2.3.12. Check of brake slips
         2.2.3.13. Check of the connecting mechanism of the emergency brake
         2.2.3.14. Valve check of restriction of pressure in a contour of back brakes
         2.2.3.15. Check of level of hydraulic liquid
         2.2.3.16. Check of system of adjustment of height of a back suspension bracket
         2.2.3.17. Check of a condition of a body
         2.2.3.18. Check of loops and locks
         2.2.3.19. Check of a maple belt of the generator
         2.2.3.20. Adjustment of headlights of head light
         2.2.3.21. Replacement of the filter
         2.2.3.22. Battery of a door key
         2.2.3.23. Check of the car in road conditions
      + 2.2.4. Maintenance each 30 000 km or in 24 months
      + 2.2.5. Maintenance each 60 000 km or in 48 months
+ 3. Engines
+ 4. Ventilation and heating
+ 5. Power supply system
+ 6. System of decrease in toxicity
+ 7. Coupling
+ 8. Transmissions
+ 9. Half shafts
+ 10. Brake system
+ 11. Suspension bracket and steering
+ 12. Body
+ 13. Electric equipment
+ 14. Electrical circuitries


0a910c3c




2.2.3.10. Ignition advancing corner

CARBURETTOR ENGINES

Check
PERFORMANCE ORDER
1. Warm up the engine, disconnect a vacuum tube from the distributor and check that the speed of idling made 700–1000 rpm.
2. Connect a stroboscope and direct a stroboscope beam to the index on a cover of a gas-distributing belt. The index has to be combined with the top notch on a pulley of a bent shaft designating 5 ° to VMT.

Adjustment

For adjustment of a corner of an advancing of ignition, turn off a tightening nut of the distributor of ignition and turn the distributor as it is necessary.

ENGINES WITH VSPRYSK FUELS

The corner of an advancing of ignition is not subject to adjustment on these models as adjustment is carried out by an electronic control unit automatically.


On the homepage